Krone EasyCut F 320 CV - Trial Run and Checking Fitting

Start-up
60
Pos: 64.55 /BA/Inbetr iebnahme/EasyCut/ Hydraulik/Hydrauli kanschluss Bild EC F280/ 320/360/ (M) @ 234\mod_13 94086580639_78.doc x @ 1864567 @ @ 1
EC-471-0
Fig. 30
Pos: 64.56 /BA/Inbetr iebnahme/Hydrau likkupplungen ansch ließen alle Maschinen/ Hydraulikkupplungen a nschließen Teil1 @ 213\ mod_1390207328923_7 8.docx @ 1749237 @ @ 1
• Set the single-action control units of the tractor to float position.
• Turn off the tractor and secure it against the possibility of rolling back.
Pos: 64.57.1 /BA/Bedi enung /EasyCut/Sc hutze/Bei Ausführung hydr aulischer Seitensc hutz @ 332\mod_14283878 61893_78.docx @ 2536 837 @ @ 1
With hydraulic side guards design
Pos: 64.57.2 /BA/Si cherheit/7. Gefahr enhinweise alt/Mäh werke/Warnung Quetschgef ahr/Senken von Seitensc hutz @ 331\mod_14278026 96458_78.docx @ 2532405 @ @ 1
WARNING!
Crushing hazard when lowering the side guards
While lowering the hydraulic side guards, there is a danger of being crushed between side
guard and upper protective cover.
• While lowering the side guards, make sure that there is no one in the danger zone.
Pos: 64.57.3 /BA/Bedi enung /EasyCut/Sc hutze/Absenken hydrau lischer Seitenschu tz_Text @ 332\mod_142838739 1162_78.docx @ 2536775 @ @ 1
• Fold down the side guards by means of double-action control unit (red1/blue1) of the
tractor.
Pos: 64.58 /BA/Inbetr iebnahme/EasyCut/Pr obelauf nach Erstmo ntage @ 3\mod_120521592 7275_78.docx @ 73555 @ 2 @ 1
7.8 Trial run after first installation
Caution!
After the first connection to the tractor, the machine must undergo a trial run.
• The machine must be in working position
• Do not switch on the PTO until the machine is resting on the ground and you are absolutely
sure that there are no persons, animals or objects in the danger zone.
• Start a trial run of the machine from the driver’s seat of the tractor only.
• Lower the machine into working position.
• Carefully switch in the PTO of the tractor.
• Slowly increase the PTO speed to 1000 rpm.
• Check that the machine is running smoothly and without vibrations.
• Reduce the PTO speed to idling and wait for the cutting discs / mower drums to come to a
stansdstill.
• Raise or lower the machine via the tractor hydraulics.
Pos: 64.59 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1