Safety
22
3.4.17 Dangers associated with certain activities: Work on the machine
Work on the machine only when it has been shut down
If the machine is not shut down and safeguarded, parts may move unintentionally or the
machine may move. Thus there is a risk of serious injuries or death.
• Prior to all repair and maintenance work, setting and cleaning work on the machine, shut
down and safeguard it, refer to chapter Safety “Shutting Down and Safeguarding the
Machine”.
Maintenance and repair work
Incorrect maintenance and repair work will endanger operational safety. As a result, accidents
may occur and people may be seriously injured or killed.
• Only perform work which is described in these operating instructions. Before performing any
work, shut down and safeguard the machine, see chapter Safety, "Shutting down and
safeguarding the machine".
• All other maintenance and repair work may be performed by a qualified service centre only.
Raised machine and machine parts
The raised machine may accidentally drop, roll away or overturn and crush or kill people.
• Do not stand under the raised machine. First put the machine down.
• Before performing any work under the machine, securely support the machine, see chapter
Safety "Securely supporting the raised machine and machine parts".
• Before performing any work on or under raised machine parts, lower the machine parts or
secure them mechanically with rigid safety supports or with a hydraulic shut-off device to
prevent them from dropping.
Danger associated with welding work
Improper welding work will endanger the operational safety of the machine. As a result,
accidents may occur and people may be seriously injured or killed.
• Before performing welding work on the machine, obtain the consent of KRONE customer
service and, if required, identify alternatives.
• Have welding work performed by experienced technicians only.
To Next Page
Loading...
Need help?
General
