Operation
64
9.10 Raising Outrigger Arms into Transport Position
CAUTION!
Before swivelling into transport position, turn off the PTO shaft.
• Before lifting the rotors from the headland position, turn off PTO shaft and wait for rotors to
come to a standstill.
• Ensure that nobody is in the swivel range of the rotors.
• Ensure that nobody is in the swivel range of the chassis.
Note
Before switching from the working to the transport position, make sure the width adjustment
(working width) is fully retracted.
Fig.
• Swivel the tine arms into the transport position.
• Switch on the tractor.
• To relieve the lockings, move the single-acting control unit (1+) into the float position.
• To raise the lockings (1), pull the operating cable (2) and keep it tensioned.
• Actuate the single-acting control unit (1+) until the outrigger arms have been raised into the
transport position.
• Release the operating cable.
• Actuate the single-acting control unit (1+) until the lockings (1) on the right and left engage
with the retaining bolt.
• Visually inspect that the retaining bolts are correctly engaged in the lockings (1).
• Move all hydraulic control units into the neutral position.
Note
Make certain the transport locks engage correctly and the actuating rope is not tight. Perform a
visual inspection to ensure the locks (1) have engaged correctly.
To Next Page
Loading...
