Safety
25
Pos: 18.9.7 /Überschr iften/Überschr iften 3/K-O/O/Ölstand skontrolle, Öl- und Fi lterelementwechse l sicher durchf ühren @ 464\mod_1466749860961_7 8.docx @ 3128448 @ 3 @ 1
3.4.3 Safely checking the oil level and changing the oil and filter element
Pos: 18.9.8 /BA/Si cherheit/3. Sic herheitsroutinenÖlstandsk ontrolle, Öl- und Fil terelementwechsel si cher durchführ en @ 492\mod_1487079943575_78. docx @ 3312286 @ @ 1
WARNING!
Perform oil level check, oil change and filter element change safely!
If oil level check, oil change and filter element change are not performed safely, the
operational safety of the machine may be affected. This may result in accidents.
• Perform oil level check, oil change and filter element change safely.
In order to perform oil level check, oil change and filter element change safely:
• Lower raised machine parts or secure them against falling, refer to chapter Safety,
“Securely Supporting Raised Machine and Machine Parts”.
• Shut down and safeguard the machine, refer to chapter Safety, “Shutting Down and
Safeguarding the Machine”.
• Observe the intervals for oil level check, oil change and filter element change, refer to
chapter Maintenance, “Maintenance Table”.
• Use only oil qualities/quantities mentioned in the consumables table, refer to chapter
Technical Data, “Consumables”.
• Clean the area around the parts (for example gearbox, high-pressure filter) and make sure
that foreign bodies do not get into the parts or the hydraulic system.
• Check existing seal rings for damage and replace them, if necessary.
• Collect escaping oil or waste oil in a container provided for that purpose and dispose of it
properly, refer to chapter Safety, “Consumables”.
Pos: 18.10 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
