Krone Swadro TS 620 Twin

To Next Page

To Previous Page

Settings

Pos: 40.6.4.9 /BA/ Einstellungen/Sch wader/Kreiselfahrwer k/Kreiselfahr werk Querneigung_TS 620 (Twin) _TS 680 (Twin)_TS 740 ( Twin) @ 247\mod_13963663 00182_78.docx @ 1924218 @ @ 1

Transverse inclination:

A change of the transverse inclination (to the direction of travel) is reached if one of the rear

guide wheels is set higher or deeper compared to the other guide wheel.

Pos: 40.6.4.10 /Layout Module /----------------Leerzeile-------------------- @ 240\mod_1395147357027_0.docx @ 1890988 @ @ 1

Pos: 40.6.4.11 /BA/ Einstellungen/Sc hwader/Kreiselfahr werkKreiselfahr werk Vorgehensweise Swadr o diverse TC und TS @ 427\mod_145 5032842030_78.doc x @ 2959284 @ @ 1

Do not step under the raised rotors.

• Only raise the outrigger arms as far as necessary to perform the changeover work.

• To set rotor inclination, dismount the rear guide wheels and move them in the hole pattern.

For better orientation, observe the basic setting of rotor inclination, refer to chapter Initial

Operation, “Rotor Inclination - Basic Setting”.

Pos: 40.6.4.12 /Layout Module /----------------Leerzeile-------------------- @ 240\mod_1395147357027_0.docx @ 1890988 @ @ 1

Pos: 40.6.4.13 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselfahr werk Feinjustierung E xzenter_Mittel- und Sei tenschwader @ 247\mod _1396419059030_78.doc x @ 1924843 @ @ 1

Vernier adjustment via eccentric cam (1):

− = Reducing rotor inclination

+ = Increasing rotor inclination

Pos: 40.6.4.14 /BA/ Einstellungen/Sc hwader/Kreiselfahr werkKreiselneigung ei nstellen über Exzen ter im Radbolzen Swadro TC 68 0_TC 760 _TC 880 @ 303\mod_14141446 84500_78.docx @ 2357644 @ @ 1

Do not step under the raised rotors.

• Raise the outrigger arms until the changeover work can be performed.

• Loosen the nut of the wheel bolt.

• Turn the eccentric (1) to set the rotor inclination.

• Tighten the nut of wheel bolt.

Pos: 40.6.4.15 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis schwer es Futter - Fahrwerk innen mögli chst niedrig einst ellen @ 4\mod_1213084838226 _78.docx @ 86157 @ @ 1

Note

If the forage is heavy, adjust the inner running gear as low as possible!

Pos: 40.6.4.16 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1