CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 ā COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 12 of 63
21. Compressor Rated Voltage
Use the compressor at the voltage indicated on the label. Using the compressor at a different voltage
can burn out or damage the electric motor.
22. Compressor Defects
If the compressor makes strange noises or vibrates excessively during operations, check that it is
functioning properly and, if necessary, contact an Authorized Service Centre.
23. Spare Parts
Use only original spare parts which can be purchased from our distributors. Use of not original
spare parts voids the warranty and can lead to compressor malfunction. Repairs must be carried out
by an Authorized Service Centre.
24. Pneumatic Circuit
Use hoses, connections and pneumatic tools rated to handle pressures above the operating pressure.
25. Tank
Never unscrew any tank connections without first checking to ensure that the pressure has been
vented. Never make holes, welds or modifications on the tank.
26. Compressor Modifications
Never make any unauthorized modifications to the compressor. Such modifications can cause
damage and serious injury. Consult an Authorized Service Centre for any operations.
27. Using the Compressor for Painting
Never use the compressor in confined spaces or near open flames. Make certain that the work area
is adequately ventilated. In addition, wear a special mask to protect nose and mouth.
28. Keep the Compressor Horizontal
To ensure correct functioning of the compressor, it is advisable to work in a near-to horizontal
position.
KEEP THIS MANUAL INTACT AND ON HAND, AVAILABLE TO ANYONE
USING THE COMPRESSOR!
WE RESERVE THE RIGHT TO MAKE ANY MODIFICATIONS DEEMED
NECESSARY WITHOUT PRIOR NOTICE!
To Next Page
Loading...
