CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 ā COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 32 of 63
The reverse rotation of the screw from the direction of the arrow shown on the body
may damage the screw!
In case of replacement of the electric motor, at the time of restart is absolutely
necessary to visually check the direction of rotation of the screw unit.
It's absolutely necessary to strictly follow the SAFETY PRECAUTIONS on the use of
the machine.
CAUTION!
Always carefully follow the SAFETY WARNINGS regarding use of the machine.
This is extremely important.
7.8 CLEANING AND DISINFECTION
Keeping the installation site and the compressor clean is essential to good machine operation and
keeps operating and maintenance costs down.
Installation site and compressor disinfection is essential to guarantee good air quality in the
compressor room and in the area where the compressed air is used (workshop).
7.9 REINSTALLATION AND REUSE
Reinstallation and reuse of the machine must be performed by qualified personnel and only after
checking the condition of the machine itself.
The points indicated in the previous chapters hold here as well.
7.10 DEMOLITION AND DISPOSAL
If the compressor is to be demolished and disposed of, this must be performed in compliance with
current regulations.
Always contact an authorized waste disposal and recycling facility.
To Next Page
Loading...
