KTC COMPACK 2 SPECIAL - Safety Devices and Signals

CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 34 of 63
8.6 SAFETY DEVICES AND SIGNALS
The machine is equipped with safety devices and signals to prevent situations dangerous for the
operator and the machine itself.
These devices and signals come in the form of labels placed at dangerous points, and alarms that are
displayed on the electronic controller.
SIGNAL
MEANING
ATTENTION:
Do not perform any maintenance
operations on this machine
before:
 having stopped all moving
parts
 have disconnected the power
supply
 have completely discharged the
pressurized air.
 Maintenance and repair must
be performed by specialized
and authorized personnel!
 Never incline the compressor
ATTENTION:
Hot surface
ATTENTION:
Component or pressurized
system
ATTENTION:
Risk of electric shock
ATTENTION:
Drain condensation
ATTENTION:
Check the oil level with the
machine stopped
ATTENTION:
See the instruction book for the
maintenance