KTC COMPACK 2 SPECIAL - Page 61

CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 61 of 63
Problem
Cause
Resolution
Oil leaking from air
filter.
High oil level.
Defective suction valve.
The compressor during
transport has been tilted
excessively.
Drain the oil until the correct level is
reached.
For the valve, contact an Authorized Service
Centre.
Opening of the
safety valve
Working pressure too high
Overpressure in the internal
circuit.
The oil separator cartridge
is clogged.
Safety valve is damaged
Restore correct working pressure from
rating plate.
Replace oil separator filter.
Replace any defective safety valve.
Excessive oil
consumption.
Oil not suitable for the
compressor operation.
Air-oil separator cartridge
spent or defective.
Oil recovery window
clogged.
Oil level too high.
Replace oil
Fill machine with the oil indicated by the
manufacturer.
Replace oil separator cartridge.
Clean or replace oil recovery window.
Top up oil until it reaches the level indicated
in the manual.