3 WORK 23
311910-10
Main work
– Connect the battery charger to the battery. Set the battery charger.
Alternative 1
Battery charger XCharge-professional EU (00029095050)
Alternative 2
Battery charger XCharge-professional US (00029095051)
Alternative 3
Battery charger XCharge-professional GB (00029095052)
Alternative 4
Battery charger XCharge-professional CH (00029095053)
Info
Follow the instructions of the charger and the manual.
– Disconnect the battery charger after charging the battery.
Guideline
The charging current, charging voltage, and charging time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
– Mount the seat. ( p. 16)
3.13 Installing the battery (All 250/300 models, XC‑W US, XC‑W Six Days US)
H00386-10
Main work
– Insert the battery into the battery compartment with the terminals facing forward
and secure with holding bracket
.
(XC‑W US, XC‑W Six Days US, All 250/300 EU/AU/US models)
Battery (HJTZ5S-FP)
(300 EXC BR)
Battery (YTX5L-BS)
–
Mount and tighten screw
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Connect positive cable
to the battery.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
–
Slide positive terminal cover
over the positive terminal.
–
Connect negative cable
to the battery.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Contact disks
must be mounted under screws
and cable sockets
with
the claws toward the battery terminal.
Finishing work
– Mount the seat. ( p. 16)