2 SETUP 3
2.1 Unpacking and setting up the vehicle
B02176-10
Condition
Packaging V2
– Remove the box and the plastic film.
Info
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
– Remove the separate enclosure and unpack it. Check that everything is
included and complete using the enclosed packing list.
– Have a lift stand available.
Lift stand (78129955100)
– Carefully loosen and remove the tension belt of the footrest mount.
Info
An assistant prevents the motorcycle from falling over.
402050-01
– Together with an assistant, take the vehicle off the pallet.
– Position the vehicle on a lift stand.
– Check the vehicle for transport damage.
H01768-10
(All EXC/EXC Six Days models)
–
Position the turn signal indicator lamp
in the speedometer bracket.
– Remove the headlight mask with the headlight. ( p. 24)
B02008-10
Condition
Packaging V12
– Remove the box and the plastic film.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
– Remove and unpack the separate enclosure and attachments. Check that every-
thing is included and complete using the enclosed packing list.
– Have a lift stand available.
Lift stand (78129955100)
– Remove the two cable ties on the triple clamp.
402051-01
– Together with an assistant, take the vehicle off the pallet.
– Position the vehicle on a lift stand.
– Check the vehicle and attachments for transport damage.
– Install the shock absorber. ( p. 19)
To Next Page
Loading...
Need help?
General
