KTM 1290 SUPERDUKE R - Changing the Turn Signal Bulb

16 ELECTRICAL SYSTEM 152
500331-10
– Fold the headlight mask up.
–
Mount and tighten screws

.
Guideline
Remaining screws, chassis M5 5 Nm (3.7 lbf ft)
16.8 Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
L01485-10
– Remove the screw on the front of the turn signal housing.
–
Carefully remove diffuser

.
–
Push bulb

lightly into the socket, turn approx. 30° counterclockwise, and pull out
of the socket.
Info
Do not touch the reflector with your fingers and keep it free from grease.
– Lightly push the new lamp into the socket and turn all the way clockwise.
Turn signal (RY10W / socket BAU15s) ( p. 188)