KTM RC 125 - 1 Means of Representation

SETUP 2
5
S01888-10
–
Position damping rubber
3
on both sides.
–
Join plug-in connector
4
of the rear mirror on both sides.
– Position the rear mirror on both sides. Mount and tighten the
screws.
– Position all controls in their exact positions on the handlebar.
– Tighten all screws.
– Check the throttle cable play. ( p. 8)
H03807-10
– Make sure that the clutch cable is attached to the clutch
release lever and secured.
– Check the clutch lever play. ( p. 7)
F01048-10
–
Mount rear reflector
5
with spring washers
6
on holding
plate
7
.
– Mount the retaining plate on the license plate holder.
– Mount the license plate holder.
– Carefully loosen and remove the tension belt over the link fork.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tension belts around the lower
triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the pallet.
Warning
Risk of injury Battery acid and battery gases cause
serious chemical burns.
– Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety
glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the 12 V
battery.
– Only charge 12 V batteries in well-ventilated
rooms.
– Rinse the affected area immediately with plenty of
water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and
consult a doctor immediately if battery acid and
battery gases get into the eyes.
– Fill the 12 V battery.