KTR-Group NVT-E Series - Factory Settings

NVT-E
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
42611 EN
14 of 27
4
Please observe protection
note ISO 16016.
Drawn:
2019-12-06 Pz/Bet
Replacing:
KTR-N dated 2019-02-14
Verified:
2019-12-06 Pz
Replaced by:
Definitions of the factory settings set:
x / x Switching point / reset point x
x / x Delay for switching/delay for resetting for switching output x
x. / x. Maximum and minimum measured value for output
x Signal characteristics of analogue output
x Switching characteristics of switching output x
/ Unit for filling level/temperature
/ Maximum / minimum filling level
x Assignment of switching output x towards filling level or temperature monitoring
Updating rate of display
Button lock
Recorded switching output
Delay for recording the minimum/maximum charging level
Delay for recording the minimum/maximum temperature

With customized parameters presetting by the factory may differ from the figures specified
in here.
Table 4: Type with 4 switching outputs
Switching outputs
Basic settings
Diagnosis
/
5% / 2%
-I- (%)
/ /
/ /
°X
/
15% / 12%
%
/ /
/ /
%
/
/ °X
/ /
/ /
/
/ °X
/ /
/ /
Table 5: Type with 2 switching outputs and 2 analogue outputs
Switching outputs
Basic settings
Diagnosis
/
5% / 2%
-I- (%)
/ /
/ /
°X
/
/ °X
%
/ /
/ /
%
Analogue outputs
/ /
/ /
/ /
/ /
4 Operation
4.6 Amendment of basic settings
4.6.10 Factory settings