NVT-E
Operating/Assembly instructions
Please observe protection
note ISO 16016.
In this menu the switching output for recording is selected. It is only possible to record one switching output.
Set recorded output
Set Jornal Out
SJ)ou
Out 1 - Out _
Parameter
out _
►►
Diagnostics menu
Diagnostic
di A
Please note:
• The figures are saved from the volatile memory to the nonvolatile memory about
every three hours.
• The data stored are overwritten after 6 months.
To record reliable values with a fluctuating filling level, a delay period to save the minimum and maximum
charging level can be set. Here the period in seconds is set during which the signal must remain continuous
before the charging level is recorded.
Delay storing Min/Max
Delay MM
do)MM
0 - 100
Parameter
___
►►
Diagnostics menu
Diagnostic
di A
Setting range:
0 .… 100 seconds
Please note:
• Open the parameter menu by pressing the button .
• Set the value via the buttons and and accept via the button (e. g. 5
(seconds)).
The device returns to the submenu.
To record reliable values in case of fluctuating temperature, a delay period to save the minimum and maximum
temperature can be set. Here the period in seconds is set during which the signal must remain continuous before
the temperature is recorded.
Delay storing Min/Max
Delay MM
dt )MM
0 - 100
Parameter
___
►►
Diagnostics menu
Diagnostic
di A
Setting range:
0 .… 100 seconds
Please note:
• Open the parameter menu by pressing the button .
• Set the value via the buttons and and accept via the button (e. g. 5
(seconds)).
The device returns to the submenu.
4.9.4 Assigning the switching output for recording
4.9.5 Delay for min./max. saving (filling level)
4.9.6 Delay for min./max. saving (temperature)
To Next Page
Loading...