Kubota B1830 - MID-Pto Section

TRANSMISSION
B1830,B2230,B2530,B3030, WSM
3-M30
[4] MID-PTO SECTION
When the PTO shift lever (1) is set to "MID-PTO" (M)
position, the PTO shift lever pulls the control rod (5). The
control rod (5) pulls the PTO shift arm (2). In this state,
the PTO shift arm (2) shifts the PTO shifter (7) reverse.
The inner spline of the PTO shifter (7) meshes the 25T
Mid PTO gear spline (11).
On the other hand, the range gear shifter arm (2)
turns the rear PTO control plate counterclockwise and
turns the rear PTO arm counterclockwise.
Since the rear PTO arm is turned counter clockwise,
the rear PTO shifter is pushed forward.
Then, the rear PTO shifter meshes the rib of the
transmission case.
In this state, the rear PTO brake shifter prevents the
independent PTO shaft from rotating itself.
(To be continued)
(1) PTO Shift Lever
(2) PTO Shift Arm
(3) Rear PTO Arm
(4) Rear PTO Control Plate
(5) Control Rod
(6) Independent PTO Clutch
(7) PTO Shifter
(8) 25T Mid PTO Gear
(9) Independent PTO Shaft
Spline
(10) Inner Spline
(11) 25T Mid Gear Spline
(12) 26T Gear
(13) Front Wheel Drive Shaft
(14) 17T-26T Mid Gear
(15) 30T Gear
(16) Mid PTO Shaft
B1830, B2230, B2530: 18T
B3030: 17T
(17) Transmission Case
(18) Rear PTO Shaft
A: From Independent PTO
Clutch
C: To Mid PTO Shaft
R: REAR PTO Position
R/M:REAR PTO / MID PTO
Position
M: MID PTO Position
KiSC issued 05, 2012 A