Kubota B1830 - Key Stop Solenoid Relay (with OPC); Starter Relay

ELECTRICAL SYSTEM
B1830,B2230,B2530,B3030, WSM
9-S13
(3) Starter Relay
Starter Relay (without OPC)
1. Open the panel board and remove the starter relay (1).
2. Apply battery voltage across 2 terminal and 4 terminal, and
check for continuity across 1 terminal and 3 terminal.
3. If 0 Ω is not indicated, renew the starter relay (1).
9Y1210003ELS0016US0
(4) Key Stop Solenoid Relay (with OPC)
Key Stop Solenoid Relay (with OPC)
1. Open the panel board and remove the key stop solenoid relay
(1).
2. Apply battery voltage across 2 terminal and 4 terminal, and
check for continuity across 1 terminal and 3 terminal.
3. If 0 Ω is not indicated, renew the key stop solenoid relay (1).
9Y1210003ELS0017US0
Resistance
1 terminal –
3 terminal
Battery
voltage is
applied
across 2
terminal
and 4
terminal
0 Ω
(1) Starter Relay 1 to 4:Terminals
Resistance
1 terminal –
3 terminal
Battery
voltage is
applied
across 2
terminal
and 4
terminal
0 Ω
(1) Key Stop Solenoid Relay 1 to 4:Terminals
KiSC issued 05, 2012 A