CABIN
B1830,B2230,B2530,B3030, WSM
10-S6
3. TIGHTENING TORQUES
Tightening torques of screws, bolts and nuts on the table below are especially specified.
(For general use screws, bolts and nuts: See page "5. TIGHTENING TORQUES" on page G-10.)
9Y1210003CAS0003US0
Item N·m kgf·m lbf·ft
Cabin mounting bolt and nuts 100 to 120 10.2 to 12.2 73.8 to 88.5
Compressor mounting screws 24.5 to 29.4 2.5 to 3.0 18.1 to 21.7
Clutch mounting screw (scroll type compressor) 10.8 to 16.2 1.10 to 1.65 8.0 to 11.9
Outer roof mounting screw 3.5 to 4.0 0.36 to 0.40 2.6 to 2.9
High pressure pipe screw and retainer nut between
compressor and condenser (High pressure pipe 1)
screw
7.8 to 11.8 0.8 to 1.2 5.8 to 8.7
High pressure pipe screw and retainer nut between
compressor and condenser (High pressure pipe 1)
retaining nut
19.6 to 24.5 2.0 to 2.5 14.5 to 18.1
High pressure pipe screw and retainer nut between
condenser and receiver screw
3.9 to 6.9 0.4 to 0.7 2.9 to 5.1
High pressure pipe screw and retainer nut between
condenser and receiver retaining nut
11.8 to 14.7 1.2 to 1.5 8.7 to 10.8
High pressure pipe screw and retainer nut between
receiver and A/C unit (High pressure pipe 2) retaining
nut
11.8 to 14.7 1.2 to 1.5 8.7 to 10.8
Low pressure pipe between A/C unit and compressor
screw
7.8 to 11.8 0.8 to 1.2 5.8 to 8.7
Low pressure pipe between A/C unit and compressor
retaining nut
29.4 to 34.3 3.0 to 3.5 21.7 to 25.3
Front wiper arm mounting nut 6.37 to 9.32 0.65 to 0.95 4.7 to 6.9
A/C unit mounting screws (M8) 9.8 to 15.7 1.0 to 1.6 7.23 to 11.6
To Next Page
Loading...
