ELECTRICAL SYSTEM
B1830,B2230,B2530,B3030, WSM
9-S22
(13) Combination Switch
Combination Switch
1. Remove the meter panel, and disconnect the combination
switch connector.
2. Remove the combination switch (1) and perform the following
checks 1) to 8).
9Y1210003ELS0026US0
1) Connector Voltage
1. Connect the combination switch connector to the main wire
harness.
2. Measure the voltage with a voltmeter across the connector B1
terminal and chassis when the main switch is ON position.
3. If the voltage differs from the battery voltage, the wiring harness
and main switch is faulty.
9Y1210003ELS0027US0
2) Head Light Switch Continuity when Setting Switch at "OFF"
Position
1. Set the light switch to the OFF position.
2. Measure the resistance with an ohmmeter across the B1
terminal (3) to the T terminal (6), the B1 terminal (3) to the 1
terminal (7).
3. If infinity is not indicated, the head light switch is faulty.
9Y1210003ELS0028US0
(1) Combination Switch
(2) 2 Terminal
(3) B1 Terminal
(4) B2 Terminal
(5) B3 Terminal
(6) T Terminal
(7) 1 Terminal
(8) R Terminal
(9) L Terminal
(10) H Terminal
Voltage
Main
switch at
ON
position
B1 terminal -
Chassis
Battery voltage
Resistance
(Switch at OFF
position)
B1 terminal – T terminal
Infinity
B1 terminal – 1 terminal
(1) Combination Switch
(2) 2 Terminal
(3) B1 Terminal
(4) B2 Terminal
(5) B3 Terminal
(6) T Terminal
(7) 1 Terminal
(8) R Terminal
(9) L Terminal
(10) H Terminal
(A) Head Light "OFF" Position
To Next Page
Loading...
