Kurzweil PC3 - Riffs; The RIFF1 Page

3-18
Setup Mode
Riffs
Riffs
RiffsarefullsongsorindividualtracksofasongcreatedinthePC3’sSongmodethatyoucan
triggerinsetupmode.StandardMIDIfilesmayalsobeimportedtoSongmodeandthenused
asriffsinsetups.Everyzoneinasetupcanhaveitʹsownriff—a
completelyindependent
sequence.Youcanuseasetupwithmanyriffstotriggerandstoploopedsequencesofdifferent
instrumentparts.Alternatively,asingleriffcanplaymultipleinstrumentparts.Eachriffcould
beusedasadifferentsongsectionofabackingtrack.
Touseariff,firstgoto
SongmodeandnotetheID#ofthesong,sectionofsongandtrackthat
youwilluseforyourriff.NextgotoSetupmodeandcreateasetup.OntheCH/PRGpageofthe
SetupEditor,choosetheprogramthatyouwanttousefortheriffon
thecurrentzone.Program
changesthatarerecordedinsongmodewillbeignoredwhenusingthesongasariffinasetup.
YoucanalsosetuptheplaybackeventfilterinSongmodetoignoreothertypesofeventsas
well.Onceyouhaveselectedyourprogram,press
themoresoftbuttonuntilyougettothe
RIFF1andRIFF2pages.Thefollowingsectionsdescribethecontentsofthesepages.
Note:Bydefault,settingazonetotriggerariffwilldisabletheabilitytoplaynotesofthatzone’s
programfromthekeyboard.Tore‐enablethisability,
seeLocal on page 3‐22.
The RIFF1 Page
ThefirstRiffpageappearsasshownbelow,andhasthefollowingparameters:
Parameter Range of Values Default
Riff Off, On Off
Song Song List 0 None
Start
(Bar) (dependent on sequence) 1
(Beat) 1 to (dependent on time signature) 1
(Tick) 0 to 959 0
Stop
(Bar) (dependent on sequence) 2
(Beat) 1 to (dependent on time signature) 1
(Tick) 0 to 959 0
Transpose Off, On Off
Root Note C -1 to G9 C4
SrcTrack (Source Track) ALL, 1 to 128 ALL
Re Channel Off, On Off