Kurzweil SP5-8 - SP5 Getting Started - Computer Sequencing; Connecting to a Computer Sequencer

Getting Started
Connecting MIDI
2-8
Connecting to a Computer Sequencer
To connect your SP5 to a computer as a MIDI controller, simply connect the SP5 to your
computer using the provided cable. If you wish to use your own cable, make sure that it is a
Type-A-to-Type-B USB cable (the USB port of the SP5 being Type B). By default, the SP5
will act as a MIDI controller (rather than a hard drive) when connected to a computer.
Scenario 1: SP5 as the MIDI controller
SP5-8
MIDI In
Module 1
MIDI Thru
Module 2
MIDI In MIDI Thru
Last Module
MIDI In
MIDI Out
Scenario 2: SP5 as the last module in the MIDI chain
MIDI In
Module 1
MIDI Thru
Module 2
MIDI In MIDI Thru
Last Module
MIDI In
MIDI Out
MIDI Controller
SP5-8