Kurzweil SP5-8 - Global Mode - MIDI Data Routing and Bank Select; Destination and Bank Select Settings

Global Mode
The Global Parameters
9-5
Destination (Dest)
The Destination parameter determines the destination of MIDI data generated by striking
keys or activating controllers. This data can be sent to the SP5 sound engine, through the
MIDI out ports, or both. You can set this parameter to any of the three destinations for this
parameter:
NOTE: In the table below, MIDI OUT applies to both the ve pin MIDI OUT and the
USB ports.
Local MIDI data is sent only to the SP5 sound engine. MIDI OUT is
disabled.
MIDI MIDI data is sent only through MIDI OUT. The sounds of the SP5
are disabled.
Local+MIDI MIDI data is sent both to the SP5 sound engine and through the
MIDI OUT.
Select the desired destination depending on your needs. If you want to play the SP5, but
not send any MIDI information to other MIDI instruments, then select Local. If you want
to use the SP5 strictly as a MIDI controller for the other modules in your MIDI chain,
then select MIDI. If you want to make use of the SP5’s sounds as well as use it as a MIDI
controller, then select Local+MIDI. Pressing both Value buttons simultaneously will set this
parameter to Local+MIDI.
Bank Select (BankSel)
The Bank Mode parameter determines the controller number with which MIDI Bank
change messages are transmitted. For MIDI Bank change messages, various manufacturers
have chosen different MIDI controller numbers. Most have chosen 0, 32, or both. You can
set this parameter to any of the following three controller IDs: Pressing both Value buttons
simultaneously will set this parameter to 0/32.
0 MIDI Bank change messages are sent with controller number 0.
32 MIDI Bank change messages are sent with controller number 32.
0/32 MIDI Bank change messages are sent with both controller numbers 0 and 32.