Setup Mode
Selecting Setups
7-2
Selecting Setups
When you are in Setup Mode, there a few ways to select Setups.
• All button—press the All button and use the Alpha Wheel or Value buttons to scroll
through the available Setups (including User Setups).
• User button—press the User button and use the Alpha Wheel or Value buttons to
scroll through the saved User Setups only.
• ID number—press the Keypad Category button and use the secondary
alphanumeric data entry function of the Category buttons to type the Setup ID
number, then press the Enter button. (Press the Keypad Category button again to
disable it.)
The Display
In Setup Mode, the top line of the display shows the current Mode and MIDI transposition.
The bottom line shows the Setup ID number and name.
Pop Up Messages
Some actions cause the display to show pop up messages. After a short time the display
returns to show the current Setup.
Alpha Wheel & Previous (–) and Next (+) Value Buttons
Use the Alpha Wheel or the Value buttons, below the display, to change the current Setup—
turning the Alpha Wheel counter-clockwise or pressing the Previous button will select the
previous Setup and turning the Alpha Wheel clockwise or pressing the Next button will
select the next Setup. When the highest or lowest Setup is reached, the list will wrap back to
the last or rst Setup respectively.
Setup Xpose:0
0 Bri tePno/Jaco
To Next Page
Loading...
