Setup Mode
User Setups
7-8
Layer Volume
This parameter determines the relative volumes of the Secondary and Primary Voices—it
can be set to any number between -127 and 127. By default, the Layer Volume is set to 0,
which results in both Voices having the same volume. When set to a positive number, the
volume for the Secondary Voice is increased while the volume for the Primary Layer is
decreased—doing the opposite has the opposite effect on the relative volumes of the Layers.
Layer Transposition
This parameter determines the transposition of the Secondary Voice relative to that of
the Primary Voice—it can be set to -24, -12, 0, 12, and 24. By default, Layer Transposition
is set to 0. Note that if the Primary Voice is transposed, then the Secondary Voice will be
transposed by the same amount in addition to being transposed by the amount set for the
Layer Transposition.
User Setups
To save the changes to the current Setup, press the Save button once. The Save button’s
LED begins to blink and the Keypad button’s LED lights. Pressing the Save button opens
the Save Dialog. The display shows the following:
The bottom line of the display shows the rst available ID number and the current Setup
name. You can save Setups with ID numbers from 1024 to 1087. When you initially press the
Save button, the SP5 always selects the next available ID number and displays the current
Setup name.
Save Setup over: 1/2
To Next Page
Loading...
