Kurzweil SP5-8 User Manual

Global Mode
The Global Parameters
9-8
Press the Next button–the display will show the message ? and the SP5 will
appear as a removable disk/drive on your computer. Press the Next button again to save
the les to the SP5 removable disk/drive. The display briey ashes a Saving... message then
shows the message . Open the SP5 removable disk/
drive and copy the le to your computer.
Pressing Previous will cancel the save operation and recall the dialog. If an error
occurs during the save operation, then the display will show the error message, .
If the SP5 is not connected to a computer, the display will show the error message
. Pressing the Previous button will recall the dialog—pressing the
Next button will retry to connect.
The Load (Overwrite)? Dialog
NOTE: If the SP5 is currently connected to your computer as a MIDI controller, eject or
Safely Remove it before continuing. Selecting the Load (Overwrite) Dialog will disconnect
any MIDI device connected via USB.
The dialog allows you to load a le containing previously saved User
Programs and User Setups from a computer connected to the SP5 via USB. Selecting
loads the previously saved User Programs and User Setups and deletes
(overwrites) the existing User Programs and Setups currently in the SP5.
With the SP5’s power off, connect a USB cable from a computer to the USB port on
the SP5’s rear panel. Power-up the SP5, press the Global button, then select the
dialog.
Press the Next button–the display will show the message and the
SP5 will appear as a removable disk/drive on your computer. Copy the file, containing
your previously saved User Programs and User Setups, from your computer into the
SP5 removable disk/drive. Pressing the Next button will load the le, the display shows
, when complete .
Pressing the Previous button will cancel the load operation and recall the
dialog.
If no le is in the SP5 temporary drive during the load or an error occurs during the
load operation, then the display will show the error message, and a message
specifying the reason for the error.
If the SP5 is not connected to a computer, the display will show the error message
. Pressing the Previous button will recall the Load (Overwrite)? dialog—pressing
the Next button will retry to connect.

Kurzweil SP5-8 Specifications

General

Keyboard number of keys	88
MIDI-keyboard number of keys	- keys
Product color	Black
Pitch bend wheel	Yes
Interface	USB
Headphone outputs	1
Input voltage	15 V
Power source type	DC
Power consumption (typical)	15 W

Weight and Dimensions

Depth	350 mm
Width	1392 mm
Height	120 mm
Weight	21000 g