19
3-2-3-1 System
The “System” tab offers a total of 9 possible choices:
Ctrl Override: When enabled*, all controller assignments mapped within the current Sound are overridden and
take on the Global mode settings instead.
*Caution: Once enabled, the only means to disable this controller is to go to Global mode (Global 1 page) and
manually set the “Override Controller” switch back to Off.
Blink Tempo: Enables the Alpha wheel LED ring to “blink” (strobe) along with the current Global BPM tempo.
ARP Enable: Turns the arpeggiator on/off. (Note: for an arp to run, one of the 8 available arps must first be
assigned to the zone in question on the Zone Edit page - see pg 31 for more detail).
ARP Latch: This destination controls the “Arp Latch” master switch (Zone Edit / Common page). When engaged,
this allows any Arp (A-H), that has its individual “Latch” parameter (ARP / Steps menu) set to “On”, to continue
to play its pattern even after all piano keys have been released.
Global BPM: This is the tempo (expressed in Beats Per Minute) applied to the entire instrument.
Pitch Bend+, Pitch Bend- : MIDI pitch bend control.
Program Change : Specify a MIDI program change (0-127) to select a given sound.Zone Activate : Enables/dis-
ables a zone.
3-2-3-2 MIDI CC
The full compliment of 128 Standard MIDI CCs can be assigned by selecting from a drop down scroll list.
3-2-3-3 AUX FX
The “Aux FX” tab offers 13 possible destinations governing the AUX FX section:
Reverb Size : Controls the size of the reverberant space.
Reverb Level : Controls the amount of reverb.
Reverb Time : Controls the length of reverb decay.
Chorus Level : Controls the amount of the chorus effect.
Chorus Feedback : Controls the level of chorus feedback.
Chorus Rate : Controls the speed of chorus modulation.
Chorus Depth : Controls the maximum detuning range of the chorus modulation.
Cho To Rev : Controls the amount of Chorus fed into the Reverb.
Delay Level : Controls the amount of delay.
Delay Time : Controls the interval of time it takes for the sound to repeat.
Delay Feedback : Controls the amount of delay feedback.
Dly To Rev : Controls the amount of Delay fed into the Reverb.
Dly To Cho : Controls the amount of Delay fed into the Chorus.
Chapter 3
Chapter 3. Sound Editing
To Next Page
Loading...
