Kurzweil SP7 Grand - Audio FX; Vocal Proc; Notes; Assigning a Pedal Target

27
Chapter 3
Chapter 3. Sound Editing
3-4-2-6 Audio FX
The “Audio FX” tab offers 4 possible destinations governing the Audio Input Mixer:
3-4-2-8 Notes
The Notes tab allows you to select individual MIDI note numbers (#0-127) to trigger from the selected pedal. The
velocity is determined by the Min/Max Value (CC pedal) or Max Value (SW pedals). This function can be usefully
for triggering percussion hits and sound effects.
Lead Process On/Off : This function turns the Lead Processing section on/off.
Auto Harm On/Off : This function turns the Auto Harmony section on/off.
Auto Harm Volume : This function controls the volume level of the Auto Harmony section.
3-4-2-7 Vocal Proc
The Vocal Processor tab offers 3 possible destinations governing the Vocal Processor section:
3-4-3 Assigning a Pedal Target - ⓐ
A Pedal’s operating region is determined by its Target
assignment. Depending on the chosen Destination,
Target selection options can be: None, Preset, System,
Zone1~16, Zone ALL, FX A~D, FX ALL, Input 1~2 and
Input ALL.
3-4-4 Assigning a Pedal Off Value - ⓑ
For SW pedals, the Off value is the value (0-127) sent
when the given Pedal is released.
For the CC pedal, the Off value sets its minimum
adjustable value (value range = 0-127).
3-4-5 Assigning a Pedal On Value - ⓒ
For SW pedals, the On value is the value (0-127) sent
when the given Pedal is depressed.
For the CC pedal, the On value sets its maximum
adjustable value (value range = 0-127).
Output Volume : This function controls the volume level of the post IFX/pre Aux FX signal.
Pan : This function adjusts the left/right balance of the post IFX/pre Aux FX signal.
Reverb Send : This function controls the amount of post IFX sent to the Aux Reverb.
ChoDly Send : This function controls the amount of post IFX signal sent to the Aux Chorus and Delay.