48
Chapter 7. Audio Mode
Chapter 7
LPF 6dB and LPF 12dB - Low pass filters that reduce high frequencies above the set frequency. 6dB and 12dB
slopes are available. The higher the slope, the steeper the cut off.
LowShelf - A low shelving filter that cuts or boosts frequencies below the set frequency.
Peak/Notch - A fully parametric filter with controls for specifying the center frequency (Freq), width of the
frequency band around the center frequency (Q) and amount of boost/cut (gain) for the specified area.
HighShelf - A high shelving filter that cuts or boosts frequencies above the set frequency.
HPF 6dB, HPF 12dB - High pass filters that reduce low frequencies below the set frequency. 6dB and 12dB
slopes are available. The higher the slope, the steeper the cut off.
7-2-4 Mod/Wah (Modulation, Wah)
see pg 39 (section 5-1-3)
7-2-5 Mix
see pg 43 (section 5-1-5)
7-3 In 1, 2 Vocal Proc
The SP7 Grand's Input 1 and 2 Vocal Processors (In 1, 2 Vocal Proc.) provide vocal-specific tools: pitch correction
and auto-harmony generation.
Reminder: the Vocal Processor menu item only appears (in the left column) when you select one of the inputs for
the “Vocal Proc. Route” parameter (Audio / General menu).
The Vocal Processor page is divided into two separate tabs: Lead Processing and Auto Harmony. At the top center
of the page is a preset selector switch which offers the following factory presets with preconfigured pitch correc-
tion and auto-harmony treatments dialed in for you to get you started: Pitch Correction (PchCor), Pitch Correction
+ Vibration (PchCor + Vib), Pitch Correction + Harmony (PchCor + Har), Tight Pitch, Digi Vocal (Digi Vox), Shaky
Vibrato, Fixed Pitch, Robot Vox, Robot Vox2, Octave Up, Flea, Select Harm.
Each process can be manually edited.
7-3-1 Lead Processing
The Lead Processing section consists of the following
parameters: Octave, Gender, Mode, Chromatic Scale
On/Off, Smooth/Pitch, Vibrato Style, Vibrato Rate
(Vib.Rate), Vibrato Depth (Vib.Depth), and Vibrato Delay
(Vib.Delay).
To Next Page
Loading...
