37
4-4-2-4 Key
The Key parameter assigns the notes you play to the individual pattern steps. Up to 5 notes are possible, labeled
K1 to K5. By assigning K1-K5 to the various steps, you determine which performed note(s) is triggered at each
step in the pattern.
Select “Fixed” to trigger the note selected as the “Fixed Key” (General tab).
4-4-2-5 Octave
The Octave parameter sets the octave of the note of the specified step (+/- 3 oct).
4-4-2-6 Pitch
The Pitch parameter transposes the pitch of the note of the specified step (+/- 12 semitones).
4-4-2-7 Step Vel. (Step Velocity)
When the Velocity Type parameter (General tab) is set to “Step”, the Step Vel. Value becomes the note velocity of
the specified step.
4-4-2-8 Step Indicator
The Step Indicator is a visual aid located at the bottom of the step grid. When the arpeggiator is running, a white
dot moves along in time, advancing with each pattern step, making for easier editing.
Norm : Plays a single note.
Rest : Adds a musical rest (silence) at the specified step.
Tie : Creates a musical tie in relation to the previous note in the pattern. A new note attack is not struck unless
the pitch itself changes.
Chord : Plays a chord instead of playing a single note for that specified step.
OFF : Turns off the specified step.
Chapter 4
Chapter 4. Multi Sound Editing
To Next Page
Loading...
