34
Chapter 4. Multi Sound Editing
Chapter 4
4-3-2-4-3 Vibrato
The Vibrato tab provides access to a variable low
frequency oscillator (LFO) with Rate, Depth, and Delay
controls that effect the pitch of the sound.
The Rate dial sets the speed of the vibrato.
The Depth dial controls the amount of pitch variation.
The Delay dial lets you set the time interval between
the start of the sound and the start of the vibrato effect.
4-3-2-4-4 Portamento
With Portamento enabled, notes played in a program
can glide from the pitch of the previously played note to
the pitch of the currently played note.
The Portamento tab provides parameters to control the
behavior of the portamento effect.
Tap the “Enable” On/Off switch to engage the
effect.Use the “Phonic” parameter to select between
Monophonic (Mono) and Polyphonic (Poly) performance.
Mono plays only one note at a time.
Poly permits polyphonic playing and note gliding.
The “Time” parameter determines the time it takes to glide between notes. Lower values create faster transitions
where higher values create slower ones.
4-3-2-4-5 AuxSend
The AuxSends tab provides effects send controls for
the Delay/Chorus and Reverb sections of the Aux FX
4-3-2-4-6 Misc
On the Miscellaneous (Misc) page you will find adjust-
ments for Fine Tuning and Pitch Bend Sensitivity.
The Fine Tuning dial allows you to tune the program +/-
100 cents (+/- 1 semitone). The Pitch Bend Sensitivity
controls the range of operation of any Pitch Bend activity
(default controller is the x-axis of the joystick). Pitch bend
can be adjusted +/- 24 semitones (+/- 2 octaves).
To Next Page
Loading...
