43
Chapter 5
Chapter 5. FX Editing
1/32 (Note: “d” = dotted values; “t” = triplet values). All values are relative to the Preset BPM tempo (as set on
the Zone Edit / Common page).
Depth - Controls the range of amplitude modulation. Lower values equal less change; higher values equal larger
swings in volume.
Shape - Controls the curvature of the modulation waveform. Lower values generate smoother/subtler (sine
wave) shapes where as higher values have a sharper, more abrupt character (square wave).
5-1-5 Mix
Mix is the final tab of the FX Bus and last process in the
chain. The Mix settings govern the post FX Bus (pre Aux
FX) sends for the aux Chorus/Delay and aux Reverb as well
as Pan and Volume settings.
Chorus/Delay - This controls the amount of post FX Bus
signal sent to the aux Chorus/Delay.
Reverb - This controls the amount of post FX Bus signal
sent to the aux Reverb.
Pan - Balance the post FX Bus signal left to right in the
stereo field.
Volume - This controls the output level of the post FX Bus
chain.
5-2-1 Delay
The Delay tab consists of a Mono/Stereo selector, Pre LPF,
High Damp, Feedback, Time, Chorus Send, Reverb Send,
and Level parameters.
Mono/Stereo Selector - Use the selector tab at the top
center of the screen to configure the delay as either mono,
stereo or off. “Mono Delay” produces a mono-centered
delay signal whereas “Stereo Delay” produces a L/R “
ping-pong” style delay.
5-2 AUX FX
The SP7 Grand features a 4 part Aux FX section which is comprised of a separate Delay, Chorus, Reverb, and
Equalizer. Adjust all parameter dials by touch, alpha wheel (once selected), Increase+/Decrease- buttons, or tap the
value field to open a numeric keypad for more precise data entry.
Pre LPF - A lowpass filter placed in front of the feedback loop can be used to attenuate the high frequencies of the
signal. Lower values produce progressively darker echoes.
High Damp - A lowpass filter placed after the delay line can be used to attenuate and color the high frequencies of the
delayed signal.
Feedback - Set the amount of delayed signal that is routed back to the input. Set to the lowest possible value to
generate a single echo. Set to the max value to endlessly repeat the signal.
Time - Sets the “delay time” based on note values: 1/2, 1/4d, 1/2t, 1/4, 1/8d, 1/4t, 1/8, 1/16d. 1/8t, 1/16, 1/32d, 1/16t,
1/32, 1/64d, 1/32t, 1/64 (Note: “d” = dotted values; “t” = triplet values). All values are relative to the Preset BPM tempo
(as set on the Zone Edit / Common page).
Chorus Send - This controls the amount of delayed signal sent to the Chorus effect section.
Reverb Send - This controls the amount of the delayed signal sent to the Reverb effect section.
Level - Adjusts the volume level of the delayed signal.
To Next Page
Loading...
