Checklist
47
Checkl ist
Tractor
Check
•
Is the inner wheel distance 110-160 cm?
•
The front inner wheel distance must be 0-10 cm larger than the rear
Mounting
Check
•
Are the hoses trapped or stretched?
•
Is the linkage geometry point of draft slightly behind the tractor
front axle?
•
Is there sufficient clearance from the tractor?
Driving on the road
The following must be carried out:
Adjust the plough to the narrowest furrow width
Stabilise the lower draw arms
Close the tap on the hydraulic control system
Ploughing
Stabilise the lower draw arms
Check
•
Is the first furrow width the same as the other furrows?
•
Is the plough frame parallel to the ground?
•
Are the beams square to the ground?
•
Are the disc coulters, skimming board and skimmers the same on
all bodies?
To Next Page