Simplified Maintenance and Repair
105
Installation of the battery
Install in the reverse sequence.
Please note, before installing the battery cover,
attach the positive pole cable to the fixing groove
inside the cover. Adjust the cable hole position after
replacing the cover, then lock the positive/negative
terminals in place. Finally, tighten the battery cover.
Tenons and grooves are provided on outer covers. To
prevent breaking the tenon by pulling or bruising it at
portion of an acute angle, you need to be very careful
when removing or installing an outer cover. If you worry
about breaking the latch, or are not confident with its
operations, please allow the KYMCO dealer shop to
handle it.
Battery tends to self-discharge and become weak
when the vehicle is left idle for a long time. Remove
Battery from the vehicle and fully re-charge it; then
store it in a cool and well ventilated place.
Remove the negative cord from the battery if the
vehicle is expected to idle for a long time.
A weakened battery voltage is displayed on the
Dashboard; you will need to remove the battery and
fully re-charge it, or go to a KYMCO service station for
service.
If battery is stored for more than 2 months, it shall be
checked monthly and re-charged if necessary.
When re-using a stored battery, fully recharge it
before installing it.
To Next Page
Loading...
Need help?
General
