Simplified Maintenance and Repair
106
Cleaning Battery Poles
For cleaning battery poles, remove a battery fixing
screw first.
If battery pole is corroded, remove the battery for
cleaning.
After cleaning, apply a thin layer of grease or Vaseline
on battery poles before installing battery.
Keep away from naked fire when removing/installing a
battery.
For removal, turn KEYLESS Main Switch to OFF
position first. Followed by removing the negative (－)
wire, then the positive (＋) wire. Connect the positive
wire first when installing, then the negative.
Fully tight a slackened nut of battery poles.
Precautions on using batteries:
1. Electrolyte in the battery contains sulfuric acid,
therefore is toxic and dangerous; severe burn may
occur on negligence; avoid getting in contact with skin,
eye or clothing. Wear goggles when working in the
vicinity of battery. In the event of following conditions,
take first aid measures as required:
Skin contact: Rinse with plenty amount of clean water.
Ingestion: Drink large amount of water or milk and
seek medical care immediately.
Eye contact: Rinse with clean water for 15 minutes
and seek medical care immediately.
2. Battery will generate explosive hydrogen, therefore
shall be kept away from any fire source (e.g. spark,
flame or lit cigarette).
Provide with sufficient ventilation if charged in an
enclosed room.
3. Store batteries in a location where children cannot
access.
4. The battery is located underneath the rear seat
cushion. Remove the rear seat cushion and remove
the seat cushion cover, and the battery will be
exposed. For re-charging the battery: When battery
power is about to deplete, immediately go to a
KYMCO dealer for re-charge. Keep in mind that the
more option devices installed on the vehicle, the faster
the battery power depletes.
To Next Page
Loading...
Need help?
General
