To start the engine without the electric starter.
1. Follow steps 1 through 4.
2. With the throttle closed, operate the kick
starter with a rapid, continuous motion.
3. Follow steps 6 through 7.
If you cannot restart a warm engine:
1. Follow steps 1 through 4.
2. Open the throttle slightly (1/8 1/4) while
starting the engine . If the throttle limiter Is
adjusted as delivered, open the throttle fully.
－
．Do not allow the kick starter to snap back
freely against the pedal stop as engine case
damage could result.
．Raise the kick starter pedal after the kick
starter lever is returned to the stop.
CAUTION:
Engine break-in
There is never a more important period in the life
of your machine than the period between zero
and 20 hours.
For this reason, we ask that you carefully read
the following material. Because the engine is
brand new, you must not put an excessive load
on it for the first 20 hours, the various parts in
the engine wear and polish themselves to the
correct operating clearances.
During this period, prolonged full throttle
operation or any condition which might result in
excessive engine heating must be avoided.
However, momentary (2~3 seconds maximum)
full throttle operation under load does not harm
the engine.
Each full throttle acceleration sequence should
be followed with a substantial rest period for the
engine by cruising at lower r/min so the engine
can rid itself of the temporary build up of heat.
If any abnormality is noticed during this period,
consult a KYMCO dealer.
54
To Next Page
Loading...
