Kyocera ECOSYS FS-1135MFP Technical Reference Manual

Chapter 6
Permanent Parameters
The printing system maintains a number of parameters in a non-volatile (flash) memory.
These parameters control the initial state of the environment at power-up, including the
initial emulation mode, page orientation, character set, buffer allocations in memory,
interface parameters, and other options.
The parameters may be changed permanently with the FRPO (Firmware RePrOgram)
command. Some FRPO parameters affect only the current interface (interface-depen-
dent) and some affect all interfaces at once (non-interface-dependent). If the printing sys-
tem is shared with other users, remember that any changes to any non-interface-
dependent parameters may interfere with the print jobs of the other users. This chapter
explains the FRPO command and gives examples of its use.
The current settings of the FRPO parameters are listed as option values on the printing
system’s service status page. Refer to the tables in this chapter to interpret the values. To
print a service status page, command:
!R! STAT 1; EXIT;
Before changing any FRPO parameter, print out a service status page, so you will know
the parameter values before the changes are made. To return FRPO parameters to their
factory default values, send the FRPO INIT (FRPO-INITialize) command.

Kyocera ECOSYS FS-1135MFP Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Duplex Printing	Yes
Standard Memory	256 MB
Connectivity	USB 2.0, Ethernet
Scanner Type	Flatbed, ADF
Scan Resolution	600 x 600 dpi
Copier Resolution	600 x 600 dpi
Fax Capability	Yes
Fax Transmission Speed	33.6 kbps
Maximum Paper Size	A4
Operating System Compatibility	Windows, Mac OS, Linux
Dimensions	494 x 430 x 448 mm
Print Speed	35 ppm
Standard Input Capacity	250 sheets
Copy Speed	Up to 35 cpm
Maximum Input Capacity	800 sheets (with optional paper feeders)