2PK/2PL/2PM/2PN
1-3-57
U632 Setting communication control 3
Description
Makes settings for fax transmission regarding the communication.
Method
1. Press the start key.
2. Select the item to be set using the cursor up/down keys.
Setting the DIS signal to 4 bytes
Sets if bit 33 and later bits of the DIS/DTC signal are sent.
1. Select the setting using the cursor up/down keys.
* : Initial setting: OFF
2. Press the start key. The setting is set.
Setting the short protocol transmission
Sets if short protocol transmission is performed.
1. Select the setting using the cursor up/down keys.
* : Initial setting: ON
2. Press the start key. The setting is set.
Setting the reception of a short protocol transmission
Selects whether to receive or ignore transmission using short protocol.
If a short protocol transmission is received when an auto switching device is attached to the
machine, communication problems, including auto switching inability, sometimes occur. Change
the setting to ignore short protocol transmission to prevent such problems.
1. Select the setting using the cursor up/down keys.
* : Initial setting: ON
2. Press the start key. The setting is set.
Item No. Description
Display Description
DIS 4BYTE Sets the DIS signal to 4 bytes.
SHORT PRTCL TX Sets the short protocol transmission.
SHORT PRTCL RX Sets the reception of short protocol transmission.
NUM OF CNG(F/T) Sets the CNG detection times in the fax/telephone auto select
mode.
Display Description
ON Bit 33 and later bits of the DIS/DTC signal are not sent.
OFF Bit 33 and later bits of the DIS/DTC signal are sent.
Display Description
ON Short protocol transmission is performed.
OFF Short protocol transmission is not performed.
Display Description
ON Receives short protocol transmission.
OFF Ignores short protocol transmission.