Troubleshooting > Troubleshooting
682
1105 "Failed to send via SMB." is displayed
Message
Failed to send via SMB.
Select [On] of the SMB settings on the Command Center RX
Job is canceled. Press [End].
1105
Corrective Actions
Make sure the protocol is set correctly.
1
Launch your Web browser.
2
In the address or location bar, enter the machine's IP address or the host name.
3
Log in with administrator privileges.
4
Click [Protocols] in the [Network Settings]
5
Set "SMB" in "Send Protocol" to [On]
6
Click [Submit].
➡ SMTP and E-mail Settings (page 120)
To Next Page
Loading...
