Troubleshooting > Troubleshooting
681
1105 "Failed to send the email." is displayed
Message
Failed to send the email.
Select [On] of the SMTP settings on the Command Center RX
Job is canceled. Press [End].
1105
Corrective Actions
From Command Center RX, check that SMTP (email sending) is On.
1
Launch your Web browser.
2
In the address or location bar, enter the machine's IP address or the host name.
3
Log in with administrator privileges.
4
Click [Protocols] of the [Network Settings] Menu.
5
Set "SMTP (E-mail TX)" in "Send Protocol" to [On]
6
Click [Submit].
➡ SMTP and E-mail Settings (page 120)
To Next Page
Loading...
