Operation Panel
4-70
3
Enter the Channel number using the numeric keys, or .
4
Press [OK]. The Custom Setup menu reappears.
Netwk Authentic. (Network Authentication setting)
This sets the authentication method to be used when connecting to an access point.
1
In the Custom Setup menu, press or to select Netwk
Authentic..
2
Press [OK]. The Netwk Authentic. screen appears.
The available authentication methods are as follows:
Open
Shared
WPA-PSK
WPA2-PSK
3
Press or to select the desired authentication method.
4
Press [OK]. The Custom Setup menu reappears.
Encryption (Encryption settings)
This selects the encryption settings.
1
In the Custom Setup menu, press or to select Encryption.
2
Press [OK]. The Encryption screen appears.
The following operations are possible:
• Data Encryption (Data Encryption setting)...4-70
• WEP Key (WEP Key settings)...4-71
• Preshared Key (Preshared Key settings)...4-71
Data Encryption (Data Encryption setting)
This sets the encryption method.
1
In the Encryption menu, press or to select Data
Encryption.
Note
The Channel can be set between 1 and 11.
Note
You can also configure the network authentication setting for WPA-Enterprise and WPA2-Enterprise using
the web page of the optional Wireless Network Interface Kit (IB-51). For details, refer to the IB-51 User's Manual.
Note
WPA-PSK and WPA2-PSK are only displayed when
Infrastructure has been set as the Connection Mode
(Switch between connection modes) on page 4-69.
Note
This setting is not displayed when the setting for Netwk Authentic. (Network Authentication setting) on page
4-70 is set to use an authentication method other than Open, Shared, WPA-PSK and WPA2-PSK, using Utility.
Note
WEP Key is displayed when Netwk Authentic.
(Network Authentication setting) on page 4-70 is set to Open
or Shared.
Preshared Key is displayed when Netwk Authentic.
(Network Authentication setting) on page 4-70 is set to WPA-
PSK or WPA2-PSK.
To Next Page
Loading...
