Kyocera ECOSYS P4040dn

4-103
Operation Panel
HTTPS (SSL Server HTTPS setting)
HTTPS (HyperText Transfer Protocol Secure) is a protocol that adds SSL data encryption, message authentication and a
digital signature function to the HTTP protocol used for data transfer between WWW servers and clients.
S-HTTP is a similar protocol, but HTTPS differs in that it uses SSL. The default setting is On.
1 In the SSL Setting menu, press  or  to select HTTPS.
2 Press [OK]. The HTTPS screen appears.
3 Press  or  to select whether HTTPS is enabled.
4 Press [OK]. The HTTPS setting is set and the SSL Setting menu
reappears.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
The default setting is Off.
1 In the Network Security menu, press  or  to select IPSec.
2 Press [OK]. The IPSec screen appears.
3 Press  or  to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Network Security
menu reappears.
ThinPrint (Thin Print setting)
Select whether or not to communicate using ThinPrint. SSL settings can also be selected. The default setting is On.
1 In the Network Security menu, press  or  to select
ThinPrint.
2 Press [OK]. The ThinPrint menu screen appears.
3 Press  or  to select Off/On.
HTTPS:
Off
01
On
02
*
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec:
Off
01
On
02
*
Note Thin Print is only displayed when the optional UG-33 has been activated.
ThinPrint:
Off/On
Exit
ThinPrintOverSSL
01
02