Kyocera ECOSYS P4040dn

Operation Panel
4-120
2 Press [OK]. The Key Login screen appears.
3 Press  or  to select Permit or Prohibit.
4 Press [OK]. The ID Card Settings menu reappears.
Additional Auth. (Setting for additional authentication)
This sets whether or not to require the entry of a Login Password or PIN (Personal Identification Number) after
authentication using an ID card. When set to On, the Login Password or PIN entry screen is displayed after the ID card is
authenticated.
1 In the ID Card Settings menu, press  or  to select
Additional Auth..
2 Press [OK]. The Additional Auth. screen appears.
3 Press  or  to select Off, Use Password or Use PIN.
4 Press [OK]. The ID Card Settings menu reappears.
Key Login:
Permit
01
Prohibit
02
*
Note This setting is only displayed when Ext. has been set as the Server Type (Server type selection) on page 4-
113.
When Use PIN is selected in this setting, even if the PIN Login is set to Off, you can enter PIN for additional
authentication.
Additional Auth.:
Off
01
02 Use Password
*
03 Use PIN