Kyocera ECOSYS P4040dn

Operation Panel
4-122
8 Enter the Login Password using the numeric keys then press [OK].
The login screen reappears.
9 Pressing [Login] ([Right Select]). If the entered Login User Name
and Login Password are correct, the User/Job Account menu
screen appears.
10 Press  or  to select Job Account.Set..
11 Press [OK]. The Job Account.Set. menu appears.
Job Accounting (Enabling Job Accounting)
Enable job accounting. Use the procedure below.
1 In the Job Account.Set. menu, press  or  to select Job
Accounting.
2 Press [OK]. The Job Accounting screen appears.
3 Press  or  to select On or Off and then press [OK]. The Job
Account.Set. menu reappears.
AccountingAccess (Setting the job accounting access)
Set the job accounting access.
1 In the Job Account.Set. menu, press  or  to select
AccountingAccess.
2 Press [OK]. The AccountingAccess screen appears.
3 Press  or  to select Local or Network, and press [OK]. The Job
Account.Set. menu reappears.
Login User Name:
Login
Login Password:
4000
Note The initial setting for the administrator's Login
Password is "4000".
For details on entering characters, refer to Character Entry
Method on page A-2.
User/Job Account:
Unknown ID Job
Exit
03
Job Account.Set.
02
01
User Login Set.
Job Account.Set.:
Account.(Local)
Exit
03
AccountingAccess
02
01
Job Accounting
Job Accounting:
Off
01
On
02
*
AccountingAccess:
Local
01
Network
02
*
Note To select Network, network authentication must be
enabled and the server type must be set. For details, refer to
Netwk Auth. Set (Netwk authentication setting) on page 4-
112.