Kyocera ECOSYS P4040dn

Troubleshooting
8-14
An SSD error has occurred. Look at the error code given in place of ##.
The possible error codes and their descriptions are as follows.
03: The SSD is write protected using command operation. Remove the write
protection using the command.
04: There is no available SSD space. Delete unnecessary files, etc., in order to
free up space.
05: The desired file does not exist in the SSD. Stored the file in the SSD.
10: The file stored in the SSD is write protected using command operation.
Remove the write protection using the command.
Copying is not possible because data with the same file name exists at the
destination. Delete the data with the same file name at the destination before
copying.
The login user name entered is not registered. Check the login user name.
The account ID set has already been registered. Register a different account ID.
The changed login user name has already been registered. Set a different login
user name.
The toner has run low. Ensure that a new toner container is available without
delay. For details, refer to Toner Container Replacement on page 7-2.
Message Corrective Action
SSD error.
Press [OK].
##
The file name
already exists.
You cannot copy.
The user name is not
registered.
This account ID is
already registered.
This login user name
already registered.
Toner is running out.