Kyocera ECOSYS P4040dn

2-5
Preparation before Use
14 Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
Entering the IP address
If DHCP is set to Off, enter the IP Address manually.
15 Press  or  to select IP Address.
16 Press [OK]. The IP Address screen appears.
17 Use the numeric keys or  or  to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use  and  to move the position being entered, which is shown
highlighted.
18 Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Entering the Subnet Mask
When DHCP is set to Off, enter the Subnet Mask manually.
19 Press  or  to select Subnet Mask.
20 Press [OK]. The Subnet Mask screen appears.
21 Use the numeric keys or  or  to set the subnet mask.
You can set any value between 000 and 255.
The method for entering is the same as for the IP Address.
22 Press [OK]. The subnet mask setting is stored and the IPv4
Setting menu reappears.
IPv4 Setting:
DHCP
Exit
01
Auto-IP
02
IP Address
03
Note DHCP becomes effective when On is selected. Press
[Menu] to end the mode selection menu.
When Off is set, continue on to enter the IP Address.
IP Address:
0. 0. 0. 0
IPv4 Setting:
DHCP
Exit
01
Auto-IP
02
IP Address
03
Subnet Mask:
0. 0. 0. 0
IPv4 Setting:
Subnet Mask
Exit
04
Default Gateway
05
Bonjour
06