Using QLINK
7-4 OPERATION GUIDE
Copy Function Section
The three copy buttons in the QLINK can be customized to allow you to take
advantage of the features built into this machine’s printer driver to do the Combine
function if you load originals in the Document Processor.
By following the figure directions below, click one of the three copy buttons in the
QLINK to copy.
Configuring the Copy Function
To configure any of the three copy buttons in the QLINK, right-click it and click
Configuration. Copy dialog box for this button appears, as shown below:
Scanner Setting
Prints 1 original image reduced to fit onto one sheet of
paper.
Prints 2 original images reduced to fit onto one sheet of
paper.
Prints 4 original images reduced to fit onto one sheet of
paper.
By clicking the arrow sign beside the drop-down list, you
can choose from the following original image types:
If the content in the original is occupied by photo images
only or by photo images with a little text on it, select 24-bit
Color to get a photo-concentrated image copy. On the
contrary, Black and White option helps you get a text-
concentrated copy. However, if the proportion of the photo
image is almost the same as that of text in the original to be
copied, it is recommended to select Mixed in order to get
the most optimal printout with photo and text mixed.
To Next Page
Loading...
