96
Care and Maintenance
Error Message Possible Cause Corrective Action
I/F occupied The front control panel
operation you attempted
is not possible because
that interface is receiving
data.
Wait until the data transfer is
completed on that interface.
Imaging unit
not locked
The imaging unit is not
locked properly because
its lever is not lifted.
Lift the imaging unit lever
fully up.
Insert the same
MEMORY CARD
A different memory card
was inserted following the
MEMORY CARD err/
Insert again message.
Reinsert the same memory
card as was removed previous-
ly into the printer’s memory
card slot.
KPDL Error ##
Press CONTINUE
The printer encountered
an error during process-
ing data in KPDL mode.
Note the error code of ## and
press CONTINUE to clear the
error situation. See section
KPDL Error Codes (☞ P. 100)
for information.
Left cover Open The left side cover is open. Close it tightly.
Load paper
<paper size>
The paper size does not
match.
Put the media cassette loaded
with the paper of the correct
size as specified by the appli-
cation software into the
printer. To resume printing
using the current media
cassette, press CONTINUE.
(You must press CONTINUE
every time one sheet has been
printed, because the same
message will again be dis-
played from the second sheet
onward.) To abandon printing,
press CANCEL.
MEMORYCARD err##
Press CONTINUE
The printer has encoun-
tered an error during
access to the memory
card.
Look at the error code of ##
preceded by MEMORYCARD
err. Then, press CONTINUE to
clear the error situation. Refer
to section Memory card errors
(☞ P. 55).
MEMORY CARD err
Insert again
The memory card was
removed during the
memory card operatin.
Re-insert the same memory
card into the printer’s memory
card slot. The printer will
continue with the memory
card operation.
Memory overflow
Press CONTINUE
The print data from the
computer is larger than
the printer can fit in its
memory.
Press CONTINUE to print the
data. Install additional memo-
ry or use a lower resolution
print quality (☞ P. 46).
Missing FK-80
Fuser KIT
The fuser kit is not
installed in the printer.
Install the fuser kit.
To Next Page
Loading...
