Kyocera FS-5800C - Other Menus (Others); Using the Printer

48
Using the Printer
■ Colour calibration
This menu provides an interface to adjust the density of the toner applied to the media.
For details on how to calibrate toner density, see Setting the Colour Density (☞P. 31).
Level 1 Level 2 Range
Colour Calibration > Print Calibration page
Cyan 00 to 20
Magenta
Yellow
Black
Other menus (Others)
The following settings are available by selecting Others at the end of the main menu. To
enter one of these menus, press the
key, then the + (or -) key.
■ Message language
The MSG language menu selects the language of the messages on the message display.
2
Level 1 Level 2 Range
Others MSG language English, French, German, Danish,
Italian, Spanish, Swedish, Japanese
2
Messages in different languages can be added by installing a ROM inside the printer electronics or
inserting a PC card in the printer’s PC card slot. For more information, see your dealer from which
you purchased the printer.
■ Formfeed timeout time
The Formfeed timeout time menu adjusts the time-out time for the occurrence of the
printer’s formfeed action. Absence of data for this period of time causes a formfeed.
Level 1 Level 2 Range
Others Form feed time out 000 to 495 (seconds)
Note:
Any value from 0 to 495 [seconds] in 5-second increments. (The printer does not time
out with the value set to 0.)
■ Sleep timer
The Sleep timer menu adjusts the period of time after which the printer’s sleep
function is activated. During “sleeping,” all indicators and the ventilating fans will go off,
conserving electricity, until an operation is made from the control panel or print data is
received.
Level 1 Level 2 Range
Others Sleep timer 000 to 120 (minutes)
Note:
Any value from 0 to 120 [minutes] in 5-minute increments.