31
Setup
Setting the Colour Density
The printer panel provides an interface to adjust the density of the toner applied to the
media. This feature compensates for the changes in density that can occur as
environmental conditions changes, toner cartridges or the imaging unit age.
Perform the following steps to adjust the colour density:
Begin by printing a Colour Calibration Page. To print a Colour
Calibration Page, proceed as follows:
1
(1)Press the MODE key on the printer panel.
(2)Press the + key repeatedly until the message display indicates
Colour Calibration.
Colour >
Calibration
(3)Press the key.
(4)Press the + key until the message display shows > Print
Calibration Page.
>Print Calibra-
tion Page
(5)Press the ENTER key. The question mark (?) will appear.
(6)Press the ENTER key again.
A Colour Calibration Page will be printed.
(2)
(3)
(4), (5)
(1)
To Next Page
Loading...
