Kyocera FS-5800C - Page 110

97
Care and Maintenance
Replace FK-80
Fuser KIT
The fuser is worn out.
Error Message Possible Cause Corrective Action
Missing IU-80
Imaging unit
The imaging unit is not
installed in the printer.
Install the imaging unit
(☞ P. 72).
Missing OS-80
Oil supply roll
The oil supply roller is not
installed in the printer.
Install the oil supply roller
(☞ P. 82).
Missing Toner
TD-80C (Cyan)
The cyan toner developer
is not installed in the
printer.
Install the cyan toner develop-
er (☞ P. 14).
Missing Toner
TD-80K (Black)
The black toner developer
is not installed in the
printer.
Install the black toner develop-
er (☞ P. 14).
Missing Toner
TD-80M (Magenta)
The magenta toner
developer is not installed
in the printer.
Install the magenta toner
developer (☞ P. 14).
Missing Toner
TD-80Y (Yellow)
The yellow toner develop-
er is not installed in the
printer.
Install the yellow toner
developer (☞ P. 14).
Missing
Charger unit
The charger unit is not
installed in the printer.
Install the charger unit in the
imaging unit.
Missing paper
feeder unit
The paper feeder unit is
not installed in the
printer.
Install the paper feeder unit.
Option feeder
Left cover Open
The paper feeder’s left
side cover is open.
Close it tightly.
Opt. ROM error
Press CONTINUE
The printer has encoun-
tered an error while
accessing data in the
option EPROM (on the
printer main board).
Press CONTINUE to print the
data processed so far. Replace
the option EPROM.
Option interface
Error ##
The printer has detected
an error on the option
interface.
Note the error code of ## and
consult your Kyocera dealer.
Output tray
paper full
The output tray has
become full.
Remove paper from the output
tray.
PJL OPMSG/STMSG The printer encountered
an error during process-
ing PJL commands.
Press CONTINUE to print the
page processed so far.
Paper jam
<Location>
Paper has become
jammed.
Remove jammed paper accord-
ing to section Removing Paper
Jam (☞ P. 75).
Print overrun
Press CONTINUE
The printer has received
print data that is too
complex to finish process-
ing in time with the
operation of the printer
mechanism.
Press CONTINUE to print the
data. Install additional memo-
ry or use a lower resolution
print quality (☞ P. 46).
Replace the fuser kit now.